Paired shade doesn't go up/down

[grigorgeous]

Hi,

My ESP32 board is az-delivery-devkit-v4 + CC1101 soldered (GPIO-18->SCLK, GPIO-05->CSN, GPIO-23->MOSI, GPIO-19->MISO, GPIO-02->TX, GPIO-04->RX).

I've successfully paired my shade (RTS 433) using Somfy 16-channel remote. At least, there was a feedback (jog) from shade during pairing (both when I pressed PROG on my remote and ESP).

However, up/my/down buttons do not do anything. The UI registers my remote's signals without any issues.
Adding more repeats and resetting rolling code didn't do the trick.

Any suggestions?

[tufanius]

I am having this same exact very issue. Please keep us all posted with this.

[splizz1st]

I have noticed the same behavior with motors that no longer had any “storage space” available. Pairing appears to be successful, but there is no more space for ESPSomfy-RTS. I believe the limit is 10 remote controls or other devices (FHEM...). The only thing that helped me was to reset the motor to factory settings.

[grigorgeous]

I have noticed the same behavior with motors that no longer had any “storage space” available. Pairing appears to be successful, but there is no more space for ESPSomfy-RTS. I believe the limit is 10 remote controls or other devices (FHEM...). The only thing that helped me was to reset the motor to factory settings.

This can be the issue actually. However, I have 11 shades on my remote, and doing so many hard resets is painful. By any chance, is there a way to simply clone my physical remote?

[tufanius]

So, I only have 1 which is my patio awning - so I am a little confused by this as being the culprit. The remote is paired, it is able to capture on the ESP side of things any remote functions I press in terms of frequency calls. Everything is lined up as expected with the exception of course the application not working.

I am thinking of pivoting to HomeSpan with SomfyPlus. It requires more programming on the IDE side of things, but I prefer to have it natively put in directly into HomeKit than the current method of Home Assistant anyways. Having said that, it looks like they call out a specific RF receiver which is the RFM69. I need to investigate exactly why the C1101 is cannot be used.

[grigorgeous]

So, I only have 1 which is my patio awning - so I am a little confused by this as being the culprit. The remote is paired, it is able to capture on the ESP side of things any remote functions I press in terms of frequency calls. Everything is lined up as expected with the exception of course the application not working.

I agree with @splizz1st that we could've bumped into a memory limit issue here, so it's not about the ESPSomfy-RTS software but rather a hardware limitation. I'll try a hard reset this spring. Pretty confident it'll do the trick. Unless I find a way to clone my remote.

[tufanius]

So, I only have 1 which is my patio awning - so I am a little confused by this as being the culprit. The remote is paired, it is able to capture on the ESP side of things any remote functions I press in terms of frequency calls. Everything is lined up as expected with the exception of course the application not working.

I agree with @splizz1st that we could've bumped into a memory limit issue here, so it's not about the ESPSomfy-RTS software but rather a hardware limitation. I'll try a hard reset this spring. Pretty confident it'll do the trick. Unless I find a way to clone my remote.

What would you suggest is the problem on my end If I only have 1 device on a remote? Even though the remote can handle more? Im a bit stumped here.