Transceiver defaults set for protocol but not bit length

[sreknob]

Hardware

ESP32-S3

Firmware version

2.4.7

Application version

2.4.7

What happened? What did you expect to happen?

Firstly - thanks so much for this project - was super easy to get going and solved the garbage range of the TaHoma hub in my house. When I was adding all my shades, couldn't help but notice I had to select the bit length every time. Only later did I discover that my remotes were transmitting 80-bit but the motors are happy to receive 56-bit commands, but anyway....

When I set the defaults for protocol and bit length on the transceiver tab, only the protocol default works when adding a new shade, while bit length is always 56, rather than 80 set on the radio page.

How to reproduce it (step by step)

1. Go to radio tab
2. Set bit length to 80 and save
3. Add a new shade
4. Protocol is defined based on the radio tab, but bit length defaults to 56 instead of 80

Logs