The AVR128DA48 features one 12-bit differential ADC. This example demonstrates the RMS voltage measurement of AC supply using differential ADC.

This MCC based MPLAB X IDE example shows how to interface an electret microphone with a microcontroller (MCU) using the Analog Signal Conditioning (OPAMP). In addition to the microphone, only one resistor and one capacitor are required.

Bare-metal C firmware for a 10W Solar PV MPPT Boost Converter running on an STM32F303K8T (Nucleo-32). Implements a 100 kHz Perturb & Observe (P&O) control loop with a 5mW jitter-suppression dead zone, discrete ADC signal conditioning (V/I telemetry), and high-speed USART live tracking diagnostics.

4th-order Butterworth Sallen-Key Low-Pass Filter using OPA2134 for anti-aliasing applications.

Electronics laboratory project studying RC smoothing filters and clipping (scissors) circuits through theory, Multisim simulations, and experimental measurements (Electronics, UNIWA).

This MCC based MPLAB X IDE example shows how to use the Analog Signal Conditioning (OPAMP) peripheral to implement a constant-current driver using just one external resistor. The constant current amperage setting can be adjusted using firmware control.

Design and simulation of a 9th-order passive LC band-pass filter (350–550 MHz) for Nyquist image suppression in a Digital Chirp Generator (DCG) signal chain.

Enhanced defect detection probability and feasibility by using Phase information on the GMR output signal

Design and simulation of first-order and second-order active filters using LTspice for analog signal conditioning, frequency response analysis, and performance evaluation.

A MATLAB system implementing signal conditioning and periodic correlation to detect exoplanetary transits in curve light signals.

Embedded weighing scale system using load cell sensing, signal conditioning, and microcontroller-based data processing

Signal conditioning system for slip detection in a two-jaw robotic gripper – LTspice, PSpice, MATLAB.